Farmington Roof Pros provides professional metal roofing in Farmington, NM for residential and commercial properties across the San Juan Basin. Metal makes obvious sense in a dry, sunny, windy place, and standing seam is the best-performing residential roof we install. There is one condition attached to that recommendation, and it is the box sitting on your roof right now.
A standing seam system works because the fasteners are concealed under the seam and the panel is free to expand and contract along its length. Every hole punched through the flat of a panel gives that movement something to tear against. A cooler curb cut into new standing seam without a non-penetrating detail is a leak with a date on it. Panel lengths in this valley regularly exceed thirty feet, and thermal movement over that span is real.
There are two honest ways forward. Move the cooler off the roof onto a ground stand or a wall-mounted platform during the reroof, which is often cheaper than people assume. Or build a raised, welded curb with a full-height upstand and a hemmed counter-flashing, so the panel is broken cleanly rather than pierced. Wall-mounting also puts the unit where a technician can service it from a ladder instead of a roof.
If neither is workable and the cooler has to stay exactly where it is, we will tell you to stay with shingles. A shingle field forgives penetrations that a metal field does not. That is a smaller invoice for us and a roof that does not disappoint you in year three, which is the trade we would make every time. Shingles are also easier to repair after somebody else has been up there working on the equipment.
For outbuildings, shops and the equipment sheds behind half the houses in this county, exposed-fastener panel is the right answer and we say so. It is a third of the price and the gaskets are the wear item. Plan on a fastener and washer replacement pass at roughly the fifteen-year mark and budget for it. Gasketed screws are cheap and the labor to replace them is not, so we quote it as a scheduled item.
Specification is where metal is won or lost. Twenty-four gauge rather than twenty-six on any exposed elevation, concealed clips sized for thermal movement, closures at eave and ridge that genuinely seal against wind-driven dust, and a Kynar finish. Cheap metal under this sun chalks and fades within a decade. Sixteen-inch panel width holds flatter under this sun than twenty-inch, with less oil canning to look at.
Our licensed and insured team brings the right materials and equipment to every job — high-temperature self-adhered underlayment, lead-flanged pipe boot collars, soldered pan flashing under a cooler stand, counter-flashing let into a masonry reglet, SBS-modified bitumen cap sheet, heat-welded TPO seams — and backs the work with a written workmanship warranty. We serve Farmington and nearby communities including Aztec, Bloomfield, Shiprock, Crouch Mesa.
What We Handle
Everything our metal roofing in Farmington covers
One crew, one point of contact, and the full range of metal roofing work in Farmington, NM. If it is on this list we do it in house rather than handing it to a subcontractor:
- metal roofing Farmington NM
- standing seam roof install
- exposed fastener metal panel
- 24 gauge metal roof
- Kynar finish metal roof
- concealed clip roof system
- metal roof over shop
- metal roof cooler curb
- metal panel gasket replacement
- metal roof ridge closure
- corrugated barn roof NM
- metal vs shingle cost
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Farmington services.
Materials, equipment and how we do metal roofing
The difference between metal roofing that lasts and metal roofing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with high-temperature self-adhered underlayment, lead-flanged pipe boot collars, soldered pan flashing under a cooler stand, counter-flashing let into a masonry reglet, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Farmington job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the San Juan Basin means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do metal roofing outside Farmington
Farmington Roof Pros covers Farmington and the surrounding communities of the San Juan Basin. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Metal Roofing in Aztec, NM — San Juan County, population 6,201
- Metal Roofing in Bloomfield, NM — San Juan County, population 7,421
- Metal Roofing in Shiprock, NM — San Juan County, population 7,718
- Metal Roofing in Crouch Mesa, NM — San Juan County, population 5,257
- Metal Roofing in Lee Acres, NM — San Juan County, population 4,170
- Metal Roofing in Kirtland, NM — San Juan County, population 585
Start on the Farmington Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Farmington Chooses Farmington Roof Pros
- ✓We quote the curbs, stacks and flues as their own line items, so you can see what the leak actually costs before deciding on the field.
- ✓Deck photographs go to you during the tear-off, not into a folder. Soft sheathing gets located and shown while there is still time to look at it.
- ✓Our inspection calendar runs late March and early October, matched to evaporative cooler startup and drain-down, because that is when a Farmington roof gets wet.
- ✓We refuse contingency agreements. You get a written price for the repair whether or not an insurer ever pays a dollar toward it.
The standards behind metal roofing
Quality here is not a matter of opinion — it is written down. The metal roofing work we do in Farmington follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every metal roofing project in Farmington gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free metal roofing free estimate in Farmington, or request a quote and we'll get right back to you.