Farmington Roof Pros provides professional fascia & soffit in Farmington, NM for residential and commercial properties across the San Juan Basin. Fascia rot is the standard diagnosis everywhere else in the country and it is usually the wrong one here. Wood on a Farmington eave rarely rots. It checks, splits, grays and loses its paint film, and the failure is ultraviolet rather than fungal.
That changes the repair. A board that is dry but weathered does not need replacing, it needs sanding, a solvent-borne primer that penetrates open grain, and two coats of an exterior acrylic rated for high ultraviolet exposure. Skipping the primer step is why so many eaves out here are on their third repaint inside a decade. Aluminum wrap over sound wood is a legitimate answer here and it ends the repainting cycle entirely.
Where we do find genuine rot, the cause is nearly always a specific traceable event rather than the weather. A gutter that has held sediment against the fascia for years. A cooler bleed-off discharging over an eave. A vent stack leaking behind the wall. Fix the source or the new board follows the old one. Two coats over a proper primer will hold eight to ten years on a south elevation, which is respectable.
Soffits fail differently and mostly mechanically. Wind-driven grit sandblasts the finish off vinyl and aluminum panels, ultraviolet makes older vinyl brittle enough to crack when a panel flexes in a gust, and panels pop out of their J-channel and start rattling. Rodents and birds then use the opening, which is how it becomes our problem. We photograph the source before replacing anything so there is a record of why the board failed.
Vented soffit panels also do real work when the house has refrigerated air, so we measure their net free area rather than assuming it. A run of solid panel where vented was specified, or intake blocked by insulation stuffed tight to the sheathing, will undo a ridge vent completely, and none of it is visible from the ground. Vinyl installed too tight in the channel also buckles in July, which is an installation error rather than wear.
We do this work alongside the reroof whenever we can. The eave is already open, the drip edge is off, the ladder is already there, and the labor is a fraction of what it costs as a separate mobilization. Doing fascia three years after the shingles is the expensive way to buy the same board. That measurement matters because ridge vent without matching intake pulls air from the house instead.
Our licensed and insured team brings the right materials and equipment to every job — high-temperature self-adhered underlayment, lead-flanged pipe boot collars, soldered pan flashing under a cooler stand, counter-flashing let into a masonry reglet, SBS-modified bitumen cap sheet, heat-welded TPO seams — and backs the work with a written workmanship warranty. We serve Farmington and nearby communities including Aztec, Bloomfield, Shiprock, Crouch Mesa.
What We Handle
Everything our fascia & soffit in Farmington covers
One crew, one point of contact, and the full range of fascia & soffit work in Farmington, NM. If it is on this list we do it in house rather than handing it to a subcontractor:
- fascia repair Farmington NM
- soffit panel replacement
- fascia board painting UV
- vented soffit net free area
- aluminum fascia wrap
- vinyl soffit cracking
- J-channel soffit repair
- rodent entry soffit
- fascia rot from gutter
- eave repair with reroof
- drip edge and fascia
- soffit intake blocked insulation
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Farmington services.
Materials, equipment and how we do fascia & soffit
The difference between fascia & soffit that lasts and fascia & soffit that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with high-temperature self-adhered underlayment, lead-flanged pipe boot collars, soldered pan flashing under a cooler stand, counter-flashing let into a masonry reglet, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Farmington job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the San Juan Basin means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do fascia & soffit outside Farmington
Farmington Roof Pros covers Farmington and the surrounding communities of the San Juan Basin. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Fascia & Soffit in Aztec, NM — San Juan County, population 6,201
- Fascia & Soffit in Bloomfield, NM — San Juan County, population 7,421
- Fascia & Soffit in Shiprock, NM — San Juan County, population 7,718
- Fascia & Soffit in Crouch Mesa, NM — San Juan County, population 5,257
- Fascia & Soffit in Lee Acres, NM — San Juan County, population 4,170
- Fascia & Soffit in Kirtland, NM — San Juan County, population 585
Start on the Farmington Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Farmington Chooses Farmington Roof Pros
- ✓We quote the curbs, stacks and flues as their own line items, so you can see what the leak actually costs before deciding on the field.
- ✓Deck photographs go to you during the tear-off, not into a folder. Soft sheathing gets located and shown while there is still time to look at it.
- ✓Our inspection calendar runs late March and early October, matched to evaporative cooler startup and drain-down, because that is when a Farmington roof gets wet.
- ✓We refuse contingency agreements. You get a written price for the repair whether or not an insurer ever pays a dollar toward it.
The standards behind fascia & soffit
Quality here is not a matter of opinion — it is written down. The fascia & soffit work we do in Farmington follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every fascia & soffit project in Farmington gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free fascia & soffit free estimate in Farmington, or request a quote and we'll get right back to you.